Service and Repair Manual
Platform Components
Platform Co mpon ents
2-1 Platform
2-1
Platform
How to R emove the Pl atform
How to Remove the Platform
Bodily injury hazard. The
procedures in this section
require specific repair skills,
lifting equipment and a suitable
workshop. Attempting this
procedure without these skills
and tools could result in death or
serious injury and significant
component damage. Dealer
service is required.
Note: Perform this procedure with the platform in
the stowed position and the platform extension
deck(s) fully retracted and locked in position.
1
Start the engine from the ground controls and
raise the platform approximately 18 feet /
5.5 m from the ground.
2
Release the safety arm latch, lift the safety
arm and rotate to a vertical position. Lock the
safety arm in position.
Note: Be sure that the safety arm is locked in the
vertical position.
3
Lower the platform onto the safety arm. Turn
the machine off.
Crushing hazard. Keep hands
clear of the safety arm when
lowering the platform.
Component damage hazard.
The link set cross tube can be
damaged if excessive force is
applied. Do not continue to lower
the platform after the safety arm
makes contact with the cross
tube.
16
4
Cut the zip ties that secure the power to
platform wiring to the bottom of the platform.
5
Cut the zip ties that secure the platform
controls wiring to the bottom of the platform.
6
Start the engine from the ground controls.
7
Raise the platform slightly and return the
safety arm to the stowed position.
8
Lower the platform to the stowed position.
Turn the machine off.
9
Locate the quick disconnect for the platform
controls under the platform at the steer end of
the machine.
10 Tag and disconnect the platform controls from
the control cable at the steer end of the
machine.
11 Remove the platform control box from the
platform and lay it off to the side.
12 Remove the mounting fasteners that hold the
platform controls quick disconnect plug to the
platform.
13 Lay the platform controls wiring off to the side.
14 Remove the AC power to platform outlet
bracket mounting fasteners.
GS-84 • GS-90
September 2016
Component damage hazard. Be
sure not to cut the power to
platform wiring.
Component damage hazard. Be
sure not to cut the power to
platform wiring.
Component damage hazard.
The platform controls wiring can
be damaged if it is kinked or
pinched.
Part No. 1272222