How To Adjust The Steer Speed; Software Configuration - Genie GS-3384 Service And Repair Manual

Service and Repair Manual
Ground Controls
How to Adj ust the Steer Speed

How to Adjust the Steer Speed

1 Pull out the red Emergency Stop button to the
on position at the platform controls.
2 Push in the red Emergency Stop button to the
off position at the ground controls.
3 Turn the key switch to ground control.
4 Press and hold both the blue platform up and
yellow platform down buttons. Pull out the red
Emergency Stop button to the on position at
the ground controls.
Result: TUNE SPEEDS is showing in the
diagnostic display window. The ECM is now in
programming mode.
5 Press the lift function enable button.
6 Use the yellow platform down arrow to scroll to
steering speed.
Result: STEERING SPEED is showing in the
diagnostic display window.
1 diagnostic display
2 blue platform up button
3 lift function enable button
4 yellow platform down button
7 Press the lift function enable button.
8 Press the yellow platform down button to
decrease the steering speed or press the blue
platform up button to increase the steering
speed.
9 Press the lift function enable button.
10 Push in the red Emergency Stop button to the
off position at the ground controls.
58
5-3 Softw are Confi gur ation
5-3

Software Configuration

The Electronic Control Module (ECM) contains
programming for all configurations of the
GS-84 and GS-90. Machines can be adjusted to a
different configuration using the buttons at the
ground controls. To determine the software
revision level, refer to Repair Procedure, How to
Determine the Revision Level.
Machine Option Definitions:
Descent Delay: This option halts descent when
the down limit switch is activated. All controls must
be released for 4 to 6 seconds before descent is
re-enabled. Required for AS and CE models.
Motion Alarm: The motion alarm will sound when
activating a function.
Motion Beacons: The flashing beacons operate
only when activating a function.
Overload: This cuts out all functions when the
platform overload pressure switch is tripped. The
red Emergency Stop button must be cycled before
any function can be resumed. Required for AS and
CE models.
Sim Operation: When enabled, this allows some
machine functions to be activated simultaneously.
Required to be disabled for AS and CE models.
Beacons: When installed on the machine, the
flashing beacons operate continuously when the
key switch is turned to ground or platform controls
and both red Emergency Stop buttons are pulled
out to the on position.
GS-84 • GS-90
September 2016
Part No. 1272222