Valve Adjustments - Traction Manifold; How To Adjust The Charge Pressure Relief Valve - Genie GS-3384 Service And Repair Manual

September 2016
7-7 Valve Adjus tments - Trac tion M ani fol d
7-7
Valve Adjustments - Traction
Manifold
How to Adj ust the Charge Pres sur e R elief Valve
How to Adjust the Charge
Pressure Relief Valve
Note: Refer to Drive Manifold Component list to
locate the charge pressure relief valve.
1 Connect a 0 to 600 psi / 0 to 50 bar pressure
gauge to test port #2 on the drive manifold.
2 Start the engine from the platform controls.
3 Drive the machine slowly in the direction
indicated by the blue arrow on the platform
controls and observe the pressure reading on
the pressure gauge. Refer to Specifications,
Hydraulic Components Specifications.
4 Component damage hazard. Driving the
machine in reverse will place excessive
pressure on the pressure gauge and will
damage the gauge. Do not drive the machine
in a reverse direction.
5 Turn the engine off. Use a wrench to hold the
charge pressure relief valve and remove the
cap (item EE).
6 Adjust the internal hex socket. Turn it
clockwise to increase the pressure or
counterclockwise to decrease the pressure.
Install the relief valve cap.
7 Repeat steps 2 through 3 to confirm the relief
valve pressure.
Part No. 1272222 GS-84 • GS-90
Service and Repair Manual
Manifolds
85