Genie GS-3384 Service And Repair Manual page 47

September 2016
30 Carefully lower the rod end of the lower lift
cylinder onto the engine cover.
31 Remove the cables and hydraulic hoses from
the number 3 inner arm (index #8) and lay the
cables and hoses off to the side.
Component damage hazard.
Cables and hoses can be
damaged if they are kinked or
pinched.
32 Remove the pin retaining fasteners from the
cable tray pivot pin at the number 3 inner arm
(index #8) on the hydraulic tank side of the
machine.
33 Place a rod through the cable tray pivot pin
and twist to remove the pin. Lower the cable
tray down.
Component damage hazard.
Cables can be damaged if they
are kinked or pinched.
34 Remove the pin retaining fasteners from the
hose tray pivot pin at the number 3 inner arm
(index #11) on the ground controls side of the
machine.
35 Place a rod through the hose tray pivot pin and
twist to remove the pin. Lower the hose tray
down.
Component damage hazard.
Hoses can be damaged if they
are kinked or pinched.
Part No. 1272222
Scissor Components
36 Secure both ends of the number 3 inner and
outer arms (index #8 and #23) together with a
strap or other suitable device.
37 Attach a lifting strap from an overhead crane
to the number 3 inner and outer arms (index
#8 and #23) at the steer end of the machine.
Do not apply any lifting pressure.
38 Attach a lifting strap from an overhead crane
to the number 3 inner and outer arms (index
#8 and #23) at the non-steer end of the
machine. Do not apply any lifting pressure.
39 Remove the pin retaining fasteners from both
number 3 pivot pins (index #10) at the
non-steer end of the machine. Do not remove
the pins.
40 Remove the pin retaining fasteners from both
number 3 pivot pins (index #25) at the steer
end of the machine. Do not remove the pins.
41 Use a slide hammer to remove both number
3 pivot pins (index #10) from the non-steer
end of the machine.
42 Use a slide hammer to remove both number
3 pivot pins (index #25) from the steer end of
the machine.
43 Carefully remove the number 3 inner and
outer arms (index #8 and #23) and upper lift
cylinder from the machine.
Note: If further disassembly of the scissor arm pair
is required, refer to Repair Procedure, How to
Disassemble a Scissor Arm Pair.
GS-84 • GS-90
Service and Repair Manual
Crushing hazard. The number
3 inner and outer arms could
become unbalanced and fall
when they are removed from the
machine if not properly
supported by the overhead
crane.
35