How To Adjust The Lift Speed - Genie GS-3384 Service And Repair Manual

September 2016
How to Adj ust the Lift Speed

How to Adjust the Lift Speed

Tip-over hazard. Do not adjust
the lift and/or drive speed
higher than specified in this
procedure. Setting drive speed
greater than specifications
could cause the machine to tip
over resulting in death or
serious injury.
1 Pull out the red Emergency Stop button to the
on position at the platform controls.
2 Push in the red Emergency Stop button to the
off position at the ground controls.
3 Turn the key switch to ground control.
4 Press and hold both the blue platform up and
yellow platform down buttons. Pull out the red
Emergency Stop button to the on position at
the ground controls.
Result: TUNE SPEEDS is showing in the
diagnostic display window. The ECM is now in
programming mode.
5 Press the lift function enable button.
6 Use the yellow platform down arrow to scroll to
lift speed.
Result: MAX LIFT SPEED is showing in the
diagnostic display window.
Part No. 1272222
7 Press the lift function enable button.
1 diagnostic display
2 blue platform up button
3 lift function enable button
4 yellow platform down button
8 Press the yellow platform down button to
decrease the maximum lift speed or press the
blue platform up button to increase the
maximum lift speed. Refer to Specifications,
Performance Specifications.
Note: The performance achieved should always be
within specifications.
9 Press the lift function enable button.
10 Push in the red Emergency Stop button to the
off position at the ground controls.
11 Check the lift speed of the machine. Refer to
Specifications, Performance Specifications.
GS-84 • GS-90
Service and Repair Manual
Ground Controls
55