Genie GS-3384 Service And Repair Manual page 105

September 2016
4 Lower the platform onto the safety arm. Turn
the engine off.
Crushing hazard. Keep hands
clear of the safety arm when
lowering the platform.
5 Attach a lifting strap from an overhead crane
to the entry ladder on the hydraulic tank side
of the machine.
6 Remove the entry ladder mounting fasteners.
Remove the entry ladder from the machine.
Crushing hazard. The entry
ladder could become
unbalanced and fall when it is
removed from the machine if it is
not properly supported.
7 Remove the retaining fasteners from the
access plate located behind the hydraulic and
fuel tank tray.
8 Close the two hydraulic shutoff valves located
at the hydraulic tank (if equipped).
open
Component damage hazard.
The engine must not be started
with the hydraulic tank shut-off
valves in the closed position or
component damage will occur. If
the tank valves are closed,
remove the key from the key
switch and tag the machine to
inform personnel of the
condition.
Part No. 1272222
9
10 Tag, disconnect and plug the two suction
11 Tag, disconnect and plug the tank return hose
12 Disconnect and plug the T-fitting located at the
13 Remove the hydraulic tank strap retaining
14 Support and secure the hydraulic tank to a
15 Remove the hydraulic tank from the machine.
closed
Note: Always use pipe thread sealant when
installing the drain plug and strainers.
GS-84 • GS-90
Service and Repair Manual
Fuel and Hydraulic Tanks
Remove the drain plug from the hydraulic tank
and completely drain the tank into a suitable
container. Refer to Specifications, Machine
Specifications.
Bodily injury hazard. Spraying
hydraulic oil can penetrate and
burn skin. Loosen hydraulic
connections very slowly to allow
the oil pressure to dissipate
gradually. Do not allow oil to
squirt or spray.
hoses that are attached to the hydraulic tank
shutoff valves.
at the tank.
tank with the 2 hoses connected to it.
fasteners and remove the hydraulic tank strap
from the machine.
suitable lifting device.
Crushing hazard. The hydraulic
tank could become unbalanced
and fall if it is not properly
supported and secured to the
lifting device when it is removed
from the machine.
Component damage hazard. Be
sure to open the two hydraulic
tank valves and prime the pump
after installing the pump.
93