How To Adjust The Raised Drive Speed - Genie GS-3384 Service And Repair Manual

September 2016
8 Press the yellow platform down button to
decrease the drive speed or press the blue
platform up button to increase the drive speed.
Refer to Specifications, Performance
Specifications.
Note: The performance achieved should always be
within specifications.
9 Press the lift function enable button.
Result: TUNE SPEEDS is showing in the
diagnostic display window. The ECM is now in
programming mode.
1 diagnostic display
2 blue platform up button
3 lift function enable button
4 yellow platform down button
10 Press the lift function enable button.
11 Use the yellow platform down arrow to scroll to
max rev high speed drive.
Result: MAX REV HIGH TORQUE DRIVE is
showing in the diagnostic display window.
12 Press the lift function enable button.
13 Press the yellow platform down button to
decrease the drive speed or press the blue
platform up button to increase the drive speed.
Refer to Specifications, Performance
Specifications.
Note: The performance achieved should always be
within specifications.
14 Press the lift function enable button.
15 Push in the red Emergency Stop button to the
off position at the ground controls.
Part No. 1272222
How to Adj ust the Rais ed Drive Speed
How to Adjust the Raised Drive
Speed
Note: On machines with software revision B1 or
lower, raised drive speeds in forward and reverse
are simultaneously adjusted, resulting in both
directions of travel operating at the same speed.
On machines with software revision C0 or higher,
the raised forward drive speed and the raised
reverse drive speed may be adjusted independent
of one another. Refer to Repair Procedure, How to
Determine the Revision Level.
Note: The GS-5390 will not drive with the platform
raised above 30 feet / 9.1 m.
1 Pull out the red Emergency Stop button to the
on position at the platform controls.
2 Push in the red Emergency Stop button to the
off position at the ground controls.
3 Turn the key switch to ground control.
4 Press and hold both the blue platform up and
yellow platform down buttons. Pull out the red
Emergency Stop button to the on position at
the ground controls.
Result: TUNE SPEEDS is showing in the
diagnostic display window. The ECM is now in
programming mode.
GS-84 • GS-90
Service and Repair Manual
Ground Controls
Tip-over hazard. Do not adjust
the lift and/or drive speed
higher than specified in this
procedure. Setting drive speed
greater than specifications
could cause the machine to tip
over resulting in death or
serious injury.
53