Genie GS-3384 Service And Repair Manual page 117

September 2016
29 Start the engine and fully raise the platform.
Result: The engine continues to run. Proceed
to step 30.
Result: An alarm sounds and the engine stops
running. Repeat this procedure beginning with
step 24.
30 Lower the platform to approximately 6 m.
31 Return the safety arm to the stowed position.
Proceed to step 59.
GS-5390 models:
32 Pull out the red Emergency Stop button to the
on position at the ground controls. Wait
3 seconds and start the engine.
Result: The alarm doesn't sound and the
engine will start and run. Proceed to step 33.
Result: The engine will not start and an alarm
is sounding. Repeat this procedure beginning
with step 12.
Note: The red Emergency Stop button must be
cycled after each quarter turn of the adjustment
screw to allow the platform overload system to
reset.
Note: Wait a minimum of 3 seconds between each
quarter turn of the adjustment screw to allow the
platform overload system to reset.
Part No. 1272222
Platform Overload Components
33 Raise the platform until the position indicator
corresponds to the maximum load position of
the capacity indicator decal.
Note: To perform this step, the system relief valve
will need to be adjusted.
Note: To help complete this part of the procedure,
apply a piece of tape to the underside of the
platform at a point which corresponds to the
maximum load position of the capacity indicator
decal before raising the platform.
Result: The engine continues to run. Proceed
to step 34.
Result: The engine has stopped and an alarm
is sounding. Proceed to step 35.
GS-84 • GS-90
Service and Repair Manual
Tip-over hazard. Raising the
platform with maximum load
above the maximum load
position, as shown on the
capacity indicator decal on the
side of the platform, could result
in the machine tipping over,
resulting in death or serious
injury. Do not raise the platform
above the maximum load
position of the capacity indicator
decal.
105