Page_Zone Module: Paging Zone Settings - VTech ErisTerminal SIP Deskset VSP736 Administrator And Provisioning Manual

page_zone Module: Paging Zone Settings

The paging zone settings allow you to define a maximum of 10 paging zones that the
VSP736 can use for multicast paging.
The paging zone parameters (except for page_zone.call_priority_threshold) follow the
format page_zone.x.[element], where x is the paging zone ID number, ranging from 1 to 10.
All the paging zone settings are included in the general configuration file.
Setting:
Description:
Values:
Setting:
Description:
Values:
Setting:
Description:
Values:
Setting:
Description:
Values:
Setting:
Description:
Values:
Configuration File Parameter Guide
VSP736 Administrator and Provisioning Manual
page_zone.x.name
Sets the paging zone name, which appears on VSP736 LCD for outgoing
and incoming multicast pages. A maximum of 15 characters is allowed.
Text string
page_zone.x.multicast_address
Enter the multicast IP address that the VSP736 will monitor. The range of
valid IP addresses is 224.0.0.0 to 239.255.255.255.
IPv4, IPv6 or FQDN
page_zone.x.multicast_port
Enter the multicast port associated with the multicast IP. The range of
valid ports is 1 to 65535.
1–65535
page_zone.x.accept_incoming_page
Enables or disables the VSP736 from receiving incoming multicast pages
for that paging zone. If disabled, the VSP736 can make outgoing
multicast pages only.
0 (disabled), 1 (enabled)
page_zone.x.priority
Set the paging zone priority from 1 to 10. Zones with a priority higher than
another zone can interrupt the lower-priority zone's active page.
1–10
210
Default: Blank
Default: Blank
Default: Blank
Default: 1
Default: 5
Back to Contents