VTech ErisTerminal SIP Deskset VSP736 Administrator And Provisioning Manual page 79

Setting
Name
Multicast IP
Multicast Port
Priority
Enable Incoming Page
Using the WebUI
VSP736 Administrator and Provisioning Manual
Description
Enter the name of the paging zone. Names can be a
maximum of 15 characters. The paging zone name is
displayed on the LCD during incoming and outgoing
multicast pages.
Enter the paging zone multicast IP address. The IP
address range for multicast addresses is
224.0.0.0–239.255.255.255.
Enter the multicast port used by the multicast IP address.
The valid port range is 1 to 65535.
Select the paging zone priority from 1 to 10. Zones with a
priority higher than another zone can interrupt the
lower-priority zone's active page.
In addition, a call priority setting is available in the
configuration file (page_zone.call_priority_threshold). This
priority setting also ranges from 1 to 10 (2 is the default). If
the paging zone priority is higher or equal to the call
priority, then a multicast page can interrupt an active,
dialing, or incoming call.
Select to enable the VSP736 to receive incoming pages for
that paging zone. If the "Enable Incoming Page" checkbox is
not selected, the phone will not listen for the multicast, but
will still be able to broadcast an outgoing page.
79
Back to Contents