VTech ErisTerminal SIP Deskset VSP736 Administrator And Provisioning Manual page 34

IPv4
1.Mode
2.Set Static IP
3.Set Static DNS
4.Set PPPoE
Back
2. With Mode selected, press
The Mode menu appears.
Mode
IP type:
Cancel
3. Press
Save
DHCP (IPv4) or Auto (IPv6) is enabled by default, which means the VSP736 will get its IP
address from the network. When DHCP and Auto are disabled, you must enter a static IP
address for the VSP736.
To set static IP for the VSP736:
1. From the Mode menu, press
If DHCP is disabled, the Set static IP menu appears. If DHCP is enabled, an error
message appears briefly before returning you to the Network setting menu.
2. On the Set static IP menu, enter the static IP address. Use the dial pad and the
Add dot
Configuration Using the Phone Menus
Select
Select
DHCP
Save
 
or to select the network mode for your network type, and then press
.
You must be familiar with TCP/IP principles and protocols to configure static IP
settings.

soft key to enter characters. Press
VSP736 Administrator and Provisioning Manual
.

to select Static IP, and then press SELECT.
or
 
or to advance to the next character.
34
Back to Contents