Figure 12-9: Static Route Table Screen - Nortel Media Gateway 3500 Installation, Operation And Maintenance Manual

Installation, Operation, Maintenance Manual
To configure the IP address for each of the Media Gateway boards,
take these 3 steps:
1. In the EMS, lock the Media Gateway.
2. In the Subnet Separation screen, do one of the following:
a.
b.
Version 3.0
If you require a single subnet, mark the Single Subnet for all media
gateway checkbox and enter the IP addresses for the following:
Global IP Address
Default Gateway Address
Subnet Mask
If your configuration requires separate subnets for OAM, Media and Control,
mark the 3 Subnet per OAM, Media and Control checkbox and enter the IP
addresses in the table for each row (OAM, Media and Control) for the
Default GW, Subnet Mask and Subnet IP.
a. For The Default GW of the Control subnet, click on the Add Static Route
button. The Static Route Table screen appears.

Figure 12-9: Static Route Table Screen

12. Operating the Media Gateway Using the EMS
119 October 2005