General Speedtouch™ Troubleshooting - THOMSON SpeedTouch 605 User Manual

Chapter 7
Troubleshooting
SpeedTouch™ does not
SpeedTouch™
unreachable
Poor SpeedTouch™
performance
188
7.1 General SpeedTouch™ Troubleshooting
If none of the LEDs light up, make sure that:
work
The SpeedTouch™ is plugged into a power socket outlet.
You are using the correct power supply for your SpeedTouch™ device.
The power requirements for your SpeedTouch™ are clearly indicated
on the identification label on the bottom of the SpeedTouch™.
The SpeedTouch™ is turned on via the rocker switch at the back panel.
If your SpeedTouch™ is cannot be reached due to misconfiguration, you might
consider a hardware reset to factory defaults as described in
Defaults" on page
However, note that resetting the SpeedTouch™ to its factory settings will
!
revoke all the changes you made to the configuration.
Make sure that the SpeedTouch™ is installed and configured as instructed in the
Installation and Setup Guide or as instructed by the Service Provider.
194.
"7.3 Reset to Factory
E-DOC-CTC-20051017-0151 v1.0