Assigning An Ip Address To The Management Port - Avaya 8800 Commissioning Manual

Remote connection configuration using EDM
Remote connection configuration navigation
•

Assigning an IP address to the management port

• Assigning static routes to the management interface
Assigning an IP address to the management port
Assign an IP address to the management port to use it for out-of-band (OOB) management.
The standby IP must be in the same subnet as the master IP. Create a virtual management
port in addition to the physical management ports on the switch management modules.
Procedure steps
1. In the Device Physical View, select the management port.
2. In the navigation tree, open the following folders: Configuration > Edit.
3. Click Mgmt Port.
4. In the Addr box, type the required IP address for the management port.
5. In the Mask box, type the subnet mask.
6. Click Apply.
7. In the Device Physical View, select the chassis.
8. In the navigation tree, open the following folders: Configuration > Edit.
9. Click Chassis.
10. In the VirtualIPAddr box, enter the IP address you want to configure as the virtual
11. In the VirtualNetMask box, enter the subnet mask.
12. Click Apply.
80 Commissioning
The Mgmt Port dialog box appears with the Mgmt Port-IP tab displayed.
The Chassis dialog box appears with the System tab displayed.
address.
on page 80
on page 81
June 2011