Table of Contents
Advertisement
17 Appendix
Setting Item
Paper size
Extended Settings
Setting Item
Paper position
17
Output quantity
546
Item
Number
2
Sets the size of paper to be printed. This setting can be made only when
[Paper Tray] is set to [Auto] or [Tray 5 (Bypass)]. This setting can be
made only for cut sheets.
[3]
[4]
[5]
[14]
[15]
[21]
[22]
[23]
[24]
[0]
Important • If [Paper Tray] is set to Tray 1, 2, 3, 4 or 6, [Paper Size] cannot be set.
Note
• If [Preset%] or [Fit to Cut Sheet] is selected for [Reduce/Enlarge], the
machine automatically calculates the magnification based on
[Original Size] and [Paper Size]. If the magnification, however, is not
within 45-210%, the original will not be reduced/enlarged, and will be
printed in a scale of 100%.
When [2 Up] is selected, the machine automatically calculates the
magnification based on [Original Size] and 1/2 of [Paper Size].
Item
Number
20
Sets the paper position.
[0] (Default)
[1]
Note
• When a continuous form paper is selected for [Original Size], [Paper
Position] cannot be set.
8
Sets the number of copies to be printed.
[1 to 250] (Default: 1): 1-250 copies
Important • When the output quantity is specified by a client, the copies of that
set of number will be printed. After printing, the number set on the
control panel will be changed to that number. However, the number
of copies specified from NetWare or lpd port will not change the
number set on the control panel.
Value
: A3
: A4
: A5
: B4
: B5
: 8.5 x 14
: 8.5 x 13
: 8.5 x 11
: 11 x 17
: Postcard
Value
: Without cut sheet feeder (left)
: With cut sheet feeder (center)
Advertisement
Table of Contents
