Table of Contents
Advertisement
Preset %
Select from preset ratios.
Note
100%
Scanned at the same size as the original.
Auto %
If the scan width of the document is greater than the maximum image size, the
scanned image is rotated 90 degrees or reduced according to the settings.
When speed dialing is used, the maximum image size will be the size registered in
the speed dialing. Otherwise, the maximum image size will be A3.
Variable %
You can scan by selecting a variable ratio. The ratio can be set within the range of 50
to 400% in 1% increments.
Stamp (Adding a Stamp when Scanning a Document)
This feature adds a stamp when scanning a document using a document feeder. A
circular stamp is added at the bottom edge of the scanned documents. You can confirm
whether or not the document has already been scanned with the stamp.
Important • This feature does not appear for some models. An optional package is necessary. For more
1
Select [Stamp].
2
Select [On].
Off
No stamp is added.
On
A stamp is added.
• Initial values for ratio other than [100%] and [Auto %] can be changed. For information on
the settings, refer to "Reduce/Enlarge Presets" (P.319).
information, contact our Customer Support Center.
• The stamp cannot be added to the following documents:
- Documents placed on the document glass
- Documents suspended by pressing the <Stop> button
- Documents suspended by paper jams
- Single-sided documents greater than 600 mm
- Two-sided documents greater than 431.8 mm
- Documents remaining on the document feeder
- Documents suspended by memory over flow
- Documents that were being scanned when suspending an immediate transmission
Scan Options
4
123
Advertisement
Table of Contents
