Table of Contents
Advertisement
11 System Settings
Address Search (Directory Service)
You can set the attributes and ranges for searching address books stored in the
directory server.
Note
1
Select [Address Search (Directory
Service.)].
2
Select the item to be set, and
select [Change Settings].
Note
3
11
Select the setting value.
4
Select [Save].
Directory Service (LDAP)
Select whether to allow the use of address books stored on the directory server.
Primary Server
Make the primary server settings of the directory server.
1
Select [Primary Server].
2
Select the item to be set, and
select [Change Settings].
3
Set the setting value.
Primary Server Setup
Select the primary server specification method from [By IP Address] and [By Server
Name].
Primary Server IP Address
Set the primary server IP address, using values from 0 to 255.
Note
Primary Server Name
Set the server name for the primary server. 64 characters are allowed.
Note
Primary Server Port Number
Set the directory server port number in the range from 1 to 65535.
326
• This feature only supports the address book used with the e-mail feature.
• Select [
] to display the
previous screen and select [
Even when [Enabled] is selected, unless the following conditions are met, the
address book of the directory server will not be started.
- The IP address must be correctly set
- The directory server (primary) IP address or Internet address must be set
- The port number used for LDAP communications must be set
• You can set this item when [Primary Server Setup] is [By IP Address].
• 224.XXX.XXX.XXX to 255.XXX.XXX.XXX and 127.XXX.XXX.XXX cannot be set.
• You can set this item when [Primary Server Setup] is [By Server Name].
] to display the next screen.
Advertisement
Table of Contents
