Making Copies - Muratec F-65 Operating Instructions Manual

Getting started

Making copies

You can make copies from your fax machine by using either the feeder or the
machine's memory.
Copying from feeder
Use this mode to make a single copy.
Note: When you make a copy from the feeder, you cannot select the normal resolu-
tion.
To make a copy from feeder:
1
Insert the document face down. Adjust the document guides for a correct fit.
2
Press . The shows:
COPY LCD
No. of Copy = 01
Note: If you enter the number of copies for each page, the machine automati-
cally switches to memory copy mode (see next column).
3
Press again to begin copying.
COPY
1.24
Copying from memory
Use this mode to make multiple copies or reduced copies. The copy reduction rate
can be set through the copy parameter settings (see page 2.4).
Note: Your machine automatically sorts multiple copies. For example, four copies
of the same two-page document will print as : 1,2 — 1,2 — 1,2 — 1,2.
To make a copy from memory:
1
Insert the document face down. Adjust the document guides for a correct fit.
2
Press . The shows:
COPY LCD
No. of Copy = 01
If you want to make one copy of each page of the document from memory,
enter 0, 1 using numeric keypad, then skip to step 4.
If not, go on to step 3.
3
Use the numeric keypad to enter the desired number of copies for each page
in the document. You may choose one ("01") to 99 copies.
Here, we chose three copies.
No. of Copy = 03
Note: The setting requires two digits. Always enter a leading zero for quan-
tities below 10 copies.
4
Press to begin the copying.
COPY
Note: In this mode, the documents are stored in the memory before copying.
If the memory of your machine becomes low, a "Memory Over Flow" mes-
sage is displayed on the
LCD
happens, press to print the documents that are already stored in mem-
COPY
ory, or press to clear all documents stored during this
CANCEL
operation.Dividing a large document into smaller batches will help you
avoid this error.
and no more documents will be stored. If this