Security Reception - Muratec F-65 Operating Instructions Manual

Beyond the basics
Using your fax machine during operation protection
1
When you press any key on your machine, the
Passcode : ****
2
Use the numeric keypad to enter the four-digit passcode (here, we enter the
passcode we set previously; see page 2.37).
Passcode :6296
If you enter the correct four-digit passcode, the machine now will let you go
on to the next step in the fax operation.
Note: If you start an operation while the first is still underway, the machine will
again ask for the passcode before proceeding with your new request.
However, the first operation will proceed unaffected, even if you fail to enter
the correct passcode for the second entry.
2.38
shows:
LCD

Security reception

With your fax machine's security reception, you can tell it to keep all received faxes
in memory and not to print them. Later, you instruct it to print out the saved faxes.
This is great if, for example, you have concerns about after-hours workers nosing
around in documents intended for your eyes only!
Important: For this feature to work, you must have preset the passcode (see page
2.37) to something besides 0000. You must also know the passcode.
Note: In the following instructions, your machine's
Transmission to Tx and the word Receive to Rx.
Activating security reception
1
Press , , 1.
PROGRAM K
Set Security Rx
2
Press . The shows:
ENTER LCD
Passcode : ****
3
Use the numeric keypad to enter the passcode. Here, we enter 6296:
Passcode :6296
4
Press . The shows:
ENTER LCD
Security Rx: Off
5
If the setting you see is acceptable, skip to step 7.
If not, go on to step 6.
6
To change the setting, press
appears. In this example, we chose "On."
Security Rx: On
7
Press . The shows the machine's current clock setting:
ENTER LCD
Time : 15:42
8
If you want security reception to begin now (and at this same time every day),
skip to step 10.
If not, go on to step 9.
shortens the word
LCD
or once or twice until the setting you want