Setting The Print Parameters - Muratec F-65 Operating Instructions Manual

Setting the print parameters

You can set two parameters for printing received fax messages:
• Print reduction rate
• Reduction margin
Print reduction rate
Print reduction lets you set the machine to reduce a large incoming document to a
size which will fit on your paper. Copy reduction lets you reduce the size of copies
made on your fax machine. Here are the options for both print reduction and copy
reduction settings:
Setting What it does
Automatically reduces printouts at variable rates down to a
minimum of 75%. Tries to reduce printout to fit on one sheet of
Auto
your selected paper size; if cannot, prints the image at 100% size
on two or more pages.
Performs no reduction. (Due to the sender's
100%
pages when receiving a one-page fax document. See 97%, below.)
Reduces an original so that the final printout of a one-page docu-
97%
ment (if the original is not larger than the paper in your machine)
will be only one page long, despite the
91%
Provides slightly more reduction.
Provides even greater reduction. Helpful for certain international
81%
stationery sizes, as well as special applications.
75% Turns legal-sized originals into US letter-sized printed copies.
For best results ...
The printout may omit a small bit of the image at the page break if the
machine tries to reduce a legal-sized page onto letter-sized paper at any set-
ting other than 75%. So whenever possible, load the correct paper size
before receiving a fax (or making a copy) of that size.
, this may print two
TTI
.
TTI
Reduction margin
Your fax machine's reduction margin is measured in millimeters (mm).
When a fax message enters your machine's electronic brain, the machine measures
the message's length and compares it to (a) the length of your selected paper plus
(b) the reduction margin you set. If the length of the incoming message is shorter
than the sum of (a) and (b), your machine prints the message on just one sheet;
otherwise, it prints the message on more than one sheet.
Note: An Auto reduction setting and a reduction margin setting of 40mm will
print most incoming faxes as single pages. Try this combination first and
then, only if you have problems with it, select different settings.
Setting the print parameters
1
Press , , 0, 2. The
PROGRAM J LCD
Print Parameters
2
Press . The shows the current set print reduction rate:
ENTER LCD
Reduc Rate :Auto
If the setting you see is acceptable, skip to step 4.
If not, go on to step 3.
3
To change the setting, press
appears.
In this example, we chose 91%.
Reduc Rate : 91%
4
Press to save the setting. The
ENTER
Margin(0-85): 40
If the setting you see is acceptable, skip to step 6.
If not, go on to step 5.
5
To change the setting, use the numeric keypad to enter the reduction margin
you want. If necessary, press
In this example, we chose 38 mm.
Margin(0-85): 38
6
Press to save the setting.
ENTER
Beyond the basics
shows:
or repeatedly until the setting you want
shows the current reduction margin:
LCD
or to move the cursor if you need.
2.3