Getting Everything Just The Way You Want It; Setting Up For Scans - Muratec F-65 Operating Instructions Manual

Beyond the basics

Getting everything just the way you want it

The EasyStart feature guided you through the "just-gotta" settings on your machine.
In the next few pages, we will cover other settings in more detail.

Setting up for scans

You can set parameters for how your fax machine scans documents:
• Primary resolution mode — Gives you four ways to send faxes, either — nor-
mal, fine or superfine resolutions — or in grayscale mode.
• Primary contrast mode — Sets how light or dark you want faxed documents
to be when they arrive at their destinations.
1
Press , , 0, 1. The
PROGRAM J
Scan Parameters
2
Press . The asks which resolution you select:
ENTER LCD
Primary: Normal
If the setting you see is acceptable, skip to step 4.
If not, go on to step 3.
3
To change the setting, press
appears. In this example, we have chosen fine resolution.
Primary: Fine
4
Press to save the setting. The
ENTER
Contrast: Normal
If the setting you see is acceptable, skip to step 6.
If not, go on to step 5.
2.2
shows:
LCD
or repeatedly until the mode you want
asks which contrast setting you select:
LCD
5
To change the setting, press
appears. In this example, we have chosen light contrast.
Contrast: Light
6
Press to save the setting.
ENTER
This section determines the resolution and contrast settings your fax will display
when you insert a document for transmission. If you choose "superfine" and "dark"
in steps 3 and 5, for example, these are the resolution and contrast settings you'll
see the next time you put a document in the document feeder.
You can always change the resolution and contrast temporarily before sending.
To adjust the resolution and contrast:
• Press to change the resolution.
RESOLUTION
• Press to change the contrast.
CONTRAST
or repeatedly until the setting you want