Creating The Rs -232 C Settings; Scanning From Your Fax To Your Computer; Printing From Your Computer To Your Fax - Muratec F-65 Operating Instructions Manual

Creating the -232 settings
RS C
Note: If you choose the wrong -232
RS
municate your computer.
1
Press , , 2,
PROGRAM L
Set RS232C
2
Press . The shows the fax's
ENTER LCD
in bps (bits per second):
Speed : Variable
Note: This setting is just for the
at which your machine sends faxes.
3
If necessary, press or to choose the appropriate baud rate for your com-
puter and software.
The settings are: Variable, or 600, 1200, 2400, 4800, 9600 or 19200 bps.
When you see your desired setting, press
Note: If using any of the Muratec-tested packages other than either
HydraFax or LaserFax, select Variable.
4
The shows:
LCD
Parity :None
If necessary, press or to choose the data parity — None, Odd, or Even —
and press .
ENTER
5
The will show:
LCD
Stop Bit : 1bit
If necessary, press or to toggle the stop bit between 1 bit or 2 bit.
When you see your desired setting, press
6
The shows:
LCD
Data Length:7bit
If necessary, press or to toggle the data length between 7 bit or 8 bit.
7
When you see the setting you want, press enter.
** Complete **
Now you are set to scan, transmit, receive and print!
parameters, your fax machine cannot com-
C
-232 transmission speed (baud rate)
RS C
-232 port. It does not change the speed
RS C
.
ENTER
.
ENTER

Scanning from your fax to your computer

You can store logos, signatures, line art or even photographs onto your computer by
using the fax machine to scan to your computer:
1
Make sure your fax is connected to your computer.
2
Fax machine: Insert the document. Adjust resolution and contrast if neces-
sary.
3
Computer: Instruct your fax software to receive. If necessary, consult your
fax software's instructions.
4
Fax machine: Press
PROGRAM
PC-FAX Scan
Your fax software now will "receive" the fax onto your computer.
To cancel scanning in progress, just press
(To cancel the command after scanning the document, consult your software's
operating instructions.)

Printing from your computer to your fax

With the -232 interface installed, you can now team your fax machine with your
RS C
personal computer for direct printing of letters, graphics and other business corre-
spondence from your computer's hard disk drive:
1
Make sure your fax is connected to your computer.
2
Computer: Use your application — for example, a word-processing pro-
gram — to send the document to your fax software, just as if
you were actually going to fax the document.
3
Fax machine: Make sure that you have stored your subscriber
number) on your machine.
Note: See pages 1.12–1.14, for more on how to enter the sub-
scriber
ID
4
Computer: When the fax software asks for the fax number to which you
are sending the document, enter your subscriber
5
Computer: Instruct your fax software to transmit. The fax machine will
begin to print.
Beyond the basics
, , 1, .
L ENTER
.
STOP
(your fax
ID
.
.
ID
2.51