Table of Contents
Advertisement
It's a great phone, too
Dialing a telephone number
1
Pick up the handset. You will hear a dial tone.
2
Dial the number by the using numeric keypad.
... or ...
• Use the one-touch dialing. (See "One-touch phone dialing," on page 2.8.)
... or ...
• Use the speed-dial. (See "Phoning via speed-dial," on page 2.10.)
... or ...
• Use the EasyDail directory (see page 2.13.)
3
When the other person answers, speak to him or her.
On-hook dialing
Because your machine has a monitor speaker, you can dial without picking up the
handset:
1
Press
/
. You will hear a dial tone and the
MONITOR
CALL
**
Tel Mode
**
2
Dial the number you want. You may use either the numeric keypad, a one-
touch key or a speed-dial number.
Note: Remember, your fax machine's monitor speaker is not a speakerphone. Be
sure to pick up the handset if the other person answers!
Note: You can also dial a fax call using on-hook dialing if you want to hear the
other machine's fax tones.
To do this, make sure there's a document in the feeder and follow the steps
for on-hook dialing. When you hear those tones, press
ument.
Hold
You can put a call on hold during a conversation by pressing
At this point, you can either hang up the handset or leave it off the hook.
To return to your conversation:
• If you hung up the handset, pick it up.
• If you didn't hang up the handset, press
Note: After you've placed someone on hold, your machine beeps at one minute
Flash
To quickly disconnect from one call and go right to the next one without having to
hang up the handset press
will show:
LCD
Redial
Press
Changing the dialing type
If your machine is set for "pulse" dialing, and you have to enter tones ("
ing a call, press #. This shows up on the LCD as the "–!" symbol. Your machine will
now "tone" dial subsequent numbers.
Note: Using this key enables tone transmission from the numeric keypad after the
to send the doc-
START
**
On Hold
**
intervals to remind you that someone is holding. If the conversation is on
hold for more than five minutes, the machine will disconnect the call auto-
matically.
.
FLASH
/
to redial the last number that the fax machine dialed.
REDIAL
PAUSE
call is connected. When you hang up the call, your machine will return to
"pulse" dialing for the next call.
Getting started
. The
shows:
HOLD
LCD
again.
HOLD
") dur-
DTMF
1.25
Advertisement
Table of Contents
