Muratec F-65 Operating Instructions Manual page 68

2
Press . The either shows:
ENTER LCD
P1:No Number
... or indicates a command is already programmed into this key.
If 1 is the key you want to program, skip to step 4. (However, our examples
P
from here will say " 3" rather than "
P
3
Select the key in which you want to program a command or change a previ-
ously stored command and then press it. Here, we select
P3:No Number
4
If you decide to select a different programmable one-touch key, go back to
step 3 before going on to step 5.
5
Press . The now shows briefly:
ENTER LCD
P3:Fax Number
then it will show either:
_ or
6
Use the numeric keypad to enter the number exactly as your machine should
dial it, including whatever codes your phone system requires. The number
can be up to 40 characters in length:
9-555-0629_
Important: Do not press
ENTER
Your display can show only 16 characters at a time. To view characters beyond
those 16, press to scroll to the left or
Note: If you make a mistake or want to erase previously entered numbers,
press to erase to the left. Or to change just one character in
CANCEL
the number, press to move the cursor to the left, or
the right, to that character and press
enter until the number is just as you want it.
7
Now, while you can still see the fax number on the
five times. The shows:
LCD
5.F-Code Tx
1.")
P
P 3.
9-555-7312_
.
to scroll to the right.
to move it to
to erase it. Then re-
CANCEL
, press -
LCD COM OPTIONS
8
Press . The shows briefly:
ENTER LCD
Enter SubAddress
_
9
Enter an - subaddress for the box to which you want to send the docu-
ITU T
ment. The - subaddress can be up to 20 characters in length and can
ITU T
include any combination of numbers and the * and # symbols. Do not include
other non-numerical characters.
In this example, we enter 6 * 54321#.
6 * 54321#_
10
Press . The display will show briefly:
ENTER
Enter Password
_
Note: If you know that this
ITU
word, skip to step 12.
11
Enter a appropriate - password for the box. The
ITU T
to 20 characters in length and can include any combination of numbers and
the * and # symbols (but no other non-numerical characters). In this example,
we enter 1 * 23456#1.
1 * 23456#1_
Note: If you make a mistake, press
rect number.
When the entry is complete, press
12
If you want the transmission to begin immediately every time you press the
key, press again and skip to step 15.
ENTER
If you want to delay the transmission, press
.
ENTER
Beyond the basics
- subaddress does not have a -
T ITU T
- password can be up
ITU T
to back up, then enter the cor-
CANCEL
.
ENTER
- , -
COM OPTIONS COM OPTIONS
pass-
,
2.33