Muratec F-65 Operating Instructions Manual page 66

9
Use the numeric keypad to enter the two-digit identifier (01–32) for the first
call group. You can specify up to 10 separate groups for each relay broadcast
initiation. Between the entry of each new group, press
a comma. Do not insert a comma after the last group number.
For example, here, we enter 0, 4,
Group No. 1,24_
Note: The shows only four characters at a time.
LCD
Important: Again, do not insert a comma after the last group number.
When finished, press .
ENTER
10
If you want the transmission to begin immediately every time you press the
key, press and skip to step 13.
ENTER
If you want to delay the transmission, press
.
ENTER
11
Instruct your fax to carry out this delayed command in one of the following
ways:
Option 1: Perform the command once at a certain time on a certain day of
the month. (For example, "Do this at 5:05
To select this option, use the numeric keypad to enter the date
and time when the fax should perform the command:
Time : 30/17:05
Option 2: Perform the command at a certain time each day you press the
key. (For example, "Do this at 5:05
To select this option, use the numeric keypad to enter 0, 0 (i. e.,
00), and then the time when the fax could perform the command:
Time : 00/17:05
12
Press , .
ENTER ENTER
13
The now displays the next programmable one-touch key.
LCD
If you do not want to enter or change any other key's programming, press
to return your machine to its usual standby mode.
If you do want to enter or change another key's programming, go back to step
4.
- to insert
COM OPTIONS
- , 1, 1, - , 2, 4:
COM OPTIONS COM OPTIONS
- , -
COM OPTIONS COM OPTIONS
on the 30th.")
PM
today.")
PM
Programming regular polling or sequential polling
Note: To erase a programmable one-touch key, refer to page 2.36.
To program a polling operation into a programmable one-touch key:
1
Press ,
PROGRAM
Enter P OneTouch
2
Press . The
ENTER
P1:No Number
... or indicates a command is already programmed into this key.
If 1 is the key you want to program, skip to step 4. (However, our examples
P
,
from here will say "
3
Select the key in which you want to program a command or change a previ-
ously stored command and then press it. Here, we select
P3:No Number
4
If you decide to select a different programmable one-touch key, go back to
step 3 before going on to step 5.
5
Press . The
ENTER
P3:Fax Number
then it will show either:
_
6
Use the numeric keypad to enter the number exactly as your machine should
dial it, including whatever codes your phone system may require. The num-
ber can be up to 40 characters in length:
9-555-0629_
STOP
Important: Do not press
If performing regular (not sequential) polling, skip to step 8.
If performing sequential polling, proceed to step 7.
, 1. The shows:
C LCD
shows either:
LCD
3" rather than " 1.")
P P
now shows briefly:
LCD
or 9-555-7312_
.
ENTER
Beyond the basics
3.
P
2.31