Table of Contents
Advertisement
Getting started
Canceling a document while sending it
To cancel a transmission in progress:
1
Press
.
STOP
• If you are using a non-memory transmission, press
until the machine returns to standby mode. The document will finish feed-
ing through the
.
ADF
• If you are using a memory transmission, the
ber in progress (see "An introduction to Review Commands," below).
For example, the
shows:
LCD
C01:5552009
2
Press
twice to cancel the transmission.
CANCEL
Note: If either broadcasting or sequential polling in progress, you cannot cancel it
by pressing
. To cancel a broadcasting or sequential polling in progress,
STOP
press
REVIEW COMMAND
An introduction to Review Commands
To cancel either an in-progress transmission or an automatic redial from memory,
use the Review Commands function.
A short explanation:
• Because your fax machine can store multiple transmission commands in memory,
it keeps track of each command by assigning it a command number — such as
"C01."
• Delayed commands, redial attempts and current fax transmissions are all stored
in your fax machine's memory and given a command number.
The Review Commands function gives you the power not only to check on each com-
mand pending in your machine's memory but also to delete a command if you decide
not to send the document.
1
Press
REVIEW COMMANDS
The
shows the first command, indicated by its command number and the
LCD
phone number it will dial.
If a command is in progress, that will be the first command the
C01:5552009
2
If this is the command you want to cancel, skip to step 4.
If not, go on to step 3.
3
Press
to continue to the next command in the command queue, then go
back to step 2.
1.20
two or three times
STOP
shows a command num-
LCD
first and then press
twice.
CANCEL
.
4
Press
CANCEL
5
If you want to cancel this command, press
6
The
LCD
If you want to cancel it go back to step 4.
If you don't want to cancel this command but do want to review other com-
mands in the queue, press
If you don't want to review any more commands, press
machine to standby mode.
This function gives you enormous control over your machine's most powerful features.
For more information on the Review Commands function, please see page 2.15.
shows:
LCD
. The
shows:
LCD
Prog/Cancel
CANCEL
now shows the next command.
or
and go back to step 2.
again.
to return the
STOP
Advertisement
Table of Contents
