Programming A Relay Broadcast Initiation - Muratec F-65 Operating Instructions Manual

Beyond the basics
8
Instruct your fax to carry out this delayed command in one of the following
ways:
Option 1: Perform the command once at a certain time on a certain day of
the month. (For example, "Do this at 5:05
To select this option, use the numeric keypad to enter the date
and time when the fax should perform the command:
Time :
Option 2: Perform the command at a certain time each day you press the
key. (For example, "Do this at 5:05
To select this option, use the numeric keypad to enter 0, 0 (i. e.,
00), and then the time when the fax could perform the command:
Time :
9
Press , .
ENTER ENTER
10
The now displays the next programmable one-touch key.
LCD
If you do not want to enter or change any other key's programming, press
to return your machine to its usual standby mode.
If you do want to enter or change this key's programming, go back to step 4.

Programming a relay broadcast initiation

Note: To erase a programmable one-touch key, refer to page 2.36.
Note: For this operation to work, three things must be true:
• The remote fax machine must be a Muratec fax machine with "hub"
capability.
• The call group(s) to which you are faxing must exist on the remote
machine.
• You must know the two-digit number for each call group that you are
faxing.
To program a relay broadcast initiation into a programmable one-touch key:
1
Press , , 1. The
PROGRAM C
Enter P OneTouch
2
Press . The either shows:
ENTER LCD
P1:No Number
2.30
on the 30th.")
PM
30/17:05
today.")
PM
00/17:05
shows:
LCD
... or indicates a command is already programmed into this key.
If 1 is the key you want to program, skip to step 4. (However, our examples
P
from here will say "
3
Select the key in which you want to program a command or change a previ-
ously stored command and then press it. Here, we select
P3:No Number
4
If you decide to select a different programmable one-touch key, go back to
step 3 before going on to step 5.
5
Press . The
ENTER
P3:Fax Number
then it will show either:
_
6
Use the numeric keypad to enter the "hub" machine's number exactly as your
STOP
machine should dial it, including whatever codes your phone system requires.
The number can be up to 40 characters in length:
9-555-0629_
Your display can show only 16 characters at a time. To view characters beyond
those 16, press
Important: Do not press
Note: If you make a mistake or want to erase previously entered numbers,
press
CANCEL
the number, press
the right, to that character. Press
until the number is just as you want it.
7
Now, while you can still see the fax number on the
three times. The
3.Relay Tx
8
Press . The
ENTER
Group No.
3" rather than " 1.")
P P
now shows briefly:
LCD
or 9-555-8743_
to scroll to the left or to scroll to the right.
.
ENTER
to erase to the left. Or to change just one character in
to move the cursor to the left, or
to erase it. Then re-enter
CANCEL
LCD
shows:
LCD
shows:
LCD
_
3.
P
to move it to
, press -
COM OPTIONS