Muratec F-65 Operating Instructions Manual page 78

4
Press to save the setting.
ENTER
What you do next depends upon what you selected in step 2 or 3:
• If either Off or Mode1, the machine will return to standby mode.
• If either Mode2 or Mode3, proceed to step 5.
5
The now asks if you want to enter a number:
LCD
BlockJunk Dial
If you want to enter or modify a number, press
Otherwise, press and skip to step 11.
PROGRAM
6
Depending on whether you already enter at least one number into the blocked
numbers list, the display shows one of the following:
01:_
If you have not entered any numbers in the blocked numbers list, skip to step 8.
If not, go on to step 7.
7
If you want to modify an existing entry in the blocked numbers list, press
or repeatedly until you see the number you want to modify. Then press
.
ENTER
... or ...
If you want to enter a new number in an already-started blocked numbers
list, press or repeatedly until you find an empty position in the list.
Then press .
ENTER
8
Use the numeric keypad to enter the last eight characters of a fax number you
want to block. For example, if you want to block a fax from someone with a
Subscriber of 972-555-3038, you should enter 5, 5, 5, -, 3, 0, 3, 8:
ID
01:555-3038_
To change only a specific digit of an entry, press
move to the right until the cursor is under the digit, then use the numeric
keypad to enter the correct digit.
Note: You can store up to 30 blocked numbers.
9
Press to save the setting. The display will show the next "slot" in the
ENTER
blocked numbers list.
If you do not want to enter or change a number for this slot, proceed to step 10.
If you do want to enter or change a number for this slot, repeat steps 6–9.
10
Press . The display now asks if you want to print the list.
STOP
Print Junk Dial
and proceed to step 6.
ENTER
or 01:555-2971
to move to the left or
11
If you do want to print the list, press
If you do not want to print it, press
normal standby mode.
Clearing a number from the blocked numbers list
To clear a number from the list:
1
Press , , 1, 1.
PROGRAM J
Block Junk Fax
2
Press . The
ENTER LCD
Block Junk
If your Block Junk Fax setting is either Mode2 or Mode3, skip to step 4.
If not, go on to step 3.
3
Press or until you see your preference, Mode2 or Mode3.
Block Junk Mode2
4
Press ,
ENTER ENTER
01:555-2971
If this is the number you want to clear, skip to step 6.
If not, go on to step 5.
5
Press or repeatedly until you see the number you want to clear.
6
Press to clear the number.
CANCEL
To clear another number from the blocked numbers list, repeat steps 5–6.
If not, go on to step 7.
to
7
Press . The
STOP LCD
Print Junk Dial
If you do want to print the list, press
If not, press to return your machine to its normal standby mode.
STOP
.
ENTER
and your machine will return to its
STOP
shows your fax's current setting:
Off
. The display shows:
now asks if you want to print the blocked numbers list.
.
ENTER
Beyond the basics
2.43