Sending/Receiving Faxes With Your Computer - Muratec F-65 Operating Instructions Manual

Beyond the basics

Sending/receiving faxes with your computer

You can receive documents from another fax onto your computer, as well as trans-
mit documents from your computer to other faxes. As with scanning, the exact
procedure for sending/receiving will vary depending upon how your computer's fax
software works.
Note: Please consult your software's operating instructions for more details.
1
Make sure your fax is connected to your computer (see page 2.50).
2
Computer: If your fax software allows it, turn off Error Correction Mode
( ).
ECM
3
Computer: Instruct your fax software to send or receive.
The fax machine will begin either transmitting or receiving.
-232 interface cable
RS C
assignment
PIN
Pin No. Signal code Signal name
1 Received data
RXD
2 Transmitted data Data signal sent from computer to your fax.
TXD
3 Clear to send
CTS
4 Signal ground
SG
5 Request to send
RTS
6 ready
DTR DTE
Signal direction
Your fax side:
MINI DIN 6 pin
1 RxD
2 TxD
3 CTS
4 S.G.
5 RTS
6 DTR
Note: Use the appropriate
know which cable you use, please contact your authorized Muratec
dealer.
2.52
Contents
The data sent to computer by your fax.
Data Enable signal for data transmission
from your fax to your computer.
Ground for signal.
Signal for request to send data.
Data Terminal Enable — ready to
communicate.
Your computer side:
DB-9 pin
1 N.C.
2 RxD
3 TxD
4 DTR
5 S.G.
6 DSR
7 RTS
8 CTS
9 N.C.
-232 cable for your machine. If you do not
RS C
" " commands
AT
Note: This is a list of standard "
AT
please consult your fax software's instructions.
Command Parameter Description
A none Call answer
D 0-9, *, # Dial number
P Pulse dial
T Tone dial
, Pause
E 0 Not echo command character
1 Echo command character
H 0 On Hook (Disconnect line)
1 Off Hook (Connect line)
M 0 Monitor speaker is always off
1 Monitor speaker is on until carrier is
detected
2 Monitor speaker is always on
P none Set pulse dial mode
T none Set tone dial mode
V 0 Short formed response code
1 Long formed response code
Z none Reset modem
&F none Initialize to factory setting
\Q 1 / flow control
XON XOFF
2 / flow control
RS CS
+ ? none Indicate current service class
FCLASS
+ =? none Indicate service class capability
FCLASS
+ =n none Set service class
FCLASS
+ =n none Receive
FRH HDLC
+ =n none / flow control (n=1)
FLO XON XOFF
none / flow control (n=2)
RS CS
+ =n none Facsimile receive message
FRM
(14400/12000/9600/7200/4800/2400bps)
+ =n none Detect silence for n 10ms
FRS
+ =n none Transmit
FTH HDLC
+ =n none Facsimile transmit message
FTM
(14400/12000/9600/7200/4800/2400bps)
+ =n none Wait for n 10ms
FTS
" modem commands. For more information,
Default value
frame (n=3:300bps)
+
FLO
frame (n=3:300bps)
E0
M1
V1
\Q2
=2