Inserting A Tape Cartridge - DEC MicroVAX 3100 Owner's Manual

4.8.3 Inserting a Tape Cartridge
The TK50Z uses TK50-K or TK52-K tape cartridges. For information on
the handling and storage of tape cartridges, see Appendix F.
Make sure the load/unload button is in the out (unload) position.
The red load/unload button comes on for approximately 4 seconds during
the tape drive automatic power-up test.
The red light goes off and the green light comes on, indicating that it is
safe to move the cartridge release handle.
If a cartridge is new, the tape drive performs a calibration sequence that
takes approximately 40 seconds. The green light flashes rapidly and
irregularly during calibration.
CAUTION:
Do not move the cartridge release handle unless the red light is
off and the green light is on.
Do not move the cartridge release handle while either light is flashing.
If the red light flashes rapidly at any time, press the load / unload button
four times. If the problem persists, do not attempt to use the tape drive or
remove the cartridge.
Figure 4-15 shows you how to insert and load a tape cartridge.
4-20
MicroVAX 3100 and VAXserver 3100 Owner's Manual