Unpacking - DEC MicroVAX 3100 Owner's Manual

relative humidity. If the system does not have a TZ30 installed, keep
the relative humidity between 10% and 90%.
• Keep the air well circulated to prevent excess heat and dust from
accumulating.
• Keep your equipment away from heaters, photocopiers, direct sunlight,
and abrasive particles.
• Before you set up your system, select a surface that is large enough to
hold the system unit. Your desk or work table is a good choice.
• Keep the area clean. Do not place food or liquid on or near your
equipment, and do not place your system unit directly on the floor.
Dust and dirt will damage the system components.
• Keep air vents clear on each side of the system unit for proper
ventilation.
• Do not place the system unit on its side. Blocking the air vents can
cause the system unit to overheat.
• Connect your system to a dedicated grounded circuit.
If you have several pieces of equipment that need to be plugged into an
electrical outlet, use a grounded power strip. Many power strips come
with an on/off switch and a surge protector.
Do not exceed the voltage requirement of the circuit.
• To avoid damaging equipment that has been moved inside from a cold
environment, let the equipment warm to room temperature before you
tum it on. Let tape cartridges stabilize for 24 hours.
2.2 Unpacking
CAUTION:
Because of the weight of the system unit, two people should
lift
the equipment out of the shipping carton and place it on a work surface.
The shipping carton contains three boxes and an accessory tray. The large
box under the accessory tray contains the system unit. The other two boxes
contain the country kit and the software licenses respectively. Figure 2-:-1
shows the contents of each box. When unpacking the boxes keep the
contents of each box separate from the others. Expansion boxes are packed
in separate cartons (see Section 4.3).
2-2 MicroVAX 3100 and VAXserver 3100 Owner's Manual