DEC MicroVAX 3100 Owner's Manual page 166

%BACKUP-I-RESUME, Resuming operation on volume 2
%BACKUP-I-READYWRITE, Mount volume 2 on MUXX: for writing
Enter "YES" when ready:
Do the following:
a. Remove the backup tape cartridge from the drive.
b. Label the tape COMPLETE SYSTEM BACKUP, number it, and
include the date.
c. Write-protect the tape cartridge.
d. Write-enable another scratch tape cartridge and insert it in the
drive.
e. When you are ready to continue, type Y (for YES) and press
RETURN. The procedure displays the following message:
%BACKUP-I-STARTVERIFY, starting verification pass
Each time the procedure displays a mount request, follow steps
a through e.
8. When the procedure is finished, it displays the following message:
%BACKUP-I-PROCDONE, operation completed. Processing finished at
19-APR-1990 15:00:00.00
If you do not want to perform another standalone BACKUP operation,
use the console to halt the system.
If you do not want to perform another standalone BACKUP operation,
ensure the standalone application volume is online and ready.
Enter "YES" to continue:
9. Press the Halt button
10. Reboot the system.
Store the backup tape cartridge in a safe place.
NOTE: The BACKUP command creates a system disk that includes a
DIGITAL-provided set of volume parameters, including a CLUSTER_SIZE
(disk access scheme) of value
1.
(The CLUSTER_SIZE parameter refers
to the way files are stored on the disk, NOT to VAXcluster environments.)
You can change most volume parameters later with the SET VOLUME
command. However, to change the CLUSTER_SIZE parameter, you must
back up the system disk that has been initialized previously with the
CLUSTER_SIZE value that you want. To prevent the BACKUP command
Backup Procedures G-9