Loading A Compact Disc - DEC MicroVAX 3100 Owner's Manual

4.6.4 Loading A Compact Disc
When you load a disc into the compact disc drive, insert the entire disc
caddy into the disc door on the drive. Do not remove the disc from the
caddy.
To load a disc:
1. Make sure the green power light on the front of the compact disc drive
is on.
2. Examine the disc caddy. Make sure that it is not cracked or damaged
in any way. Never load a damaged caddy into a compact disc drive.
3. Insert the disc caddy as shown in Figure 4-10. The label on the disc
should always be facing up when you insert the disc into the drive.
Make sure the notches on the left side of the disc caddy line up with
the notches on the door of the drive.
NOTE:
If you have the disc positioned label side up and the notches are
on the right, then the disc is oriented improperly in the caddy. Proceed
no further with the disc loading.
4. Slide the caddy in as far as it will go and then remove it. When removed,
you will notice that the disc and its housing remain in the drive. Only
the transparent sleeve comes out.
The green activity light should come on within 5 seconds. If the drive
accepted the disc and caddy, and the activity light does not light, then
the disc may be sitting incorrectly in the caddy. Remove the disc and
then check to make sure that the label is facing up as you insert the
disc into the drive again. If the activity light still does not come on,
there may be a problem with the RRD40. Contact your local DIGITAL
Service Representative.
Expanding Your System 4-13