Connecting A Terminal; Connecting The Power Cord - DEC MicroVAX 3100 Owner's Manual

Figure 2-8: Connecting the Power Cord
System Power Cord - - - - . ; - - - - - - - -
MLO-002768
2.3.6 Connecting a Terminal
NOTE:
Make sure that the power ON/OFF switch on the terminal is in the
OFF position.
The terminal must be set at 9600 baud, with 8 bits, and no parity. See
your terminal documentation if you need information on setting up your
terminal.
NOTE:
If you connect the terminal cable to one of the MMJ ports on the
rear of a VT3xx terminal, you must set the port for DEC-423 operation. See
your terminal documentation for details.
Connect the terminal cable supplied with the system (see Figure 2-1) to
MMJ port 1 on the rear panel of the system unit as shown in Figure 2-9.
Connect the other end of the. console cable to the communications port on
the terminal.
2-10
MicroVAX 3100 and VAXserver 3100 Owner's Manual