DEC MicroVAX 3100 Owner's Manual page 161

NOTE:
If you have a tape cartridge distribution kit, you already have
standalone BACKUP on a tape· cartridge. If the original tape cartridge
becomes damaged, or if you need to make extra copies, use the procedure in
this section.
1. Obtain a blank tape cartridge. Write the name on the paper label. For
example, you would use the name S/A BKUP V5.2 TK50 to build a
version 5.2 kit. Insert the label into the label slot.
2. Write-enable the tape cartridge.
3. Insert the tape cartridge labeled S/A BKUP V5.2 TK50 in the tape
cartridge drive.
4. Log in to the SYSTEM account.
5. Enter the following command:
$
@SYS$UPDATE:STABACKIT
I
Rffiurn
I
6. The procedure asks for the name of the target device. Enter MKA500
for example:
%STABACKIT-I-SYMDEL, all global symbols deleted
Enter the name of the device on which to build the kit:
MKA500
I
Return
I
7. The procedures displays the following message:
Please place the scratch tape cartridge in drive _MKA500:
This volume will receive the volume label SYSTEM.
Enter "YES" when ready:
8. When you are ready to continue, type Y (for YES) and press RETURN.
9. The system displays verification messages informing you that files are
being copied.
10. When standalone BACKUP is installed, the procedure displays a
message similar to the following:
Ending time 19-APR-1990 13:45:29.90
Starting time 19-APR-1990 13:22:39.05
The kit is complete.
$
G-4 MicroVAX 3100 and VAXserver 3100 Owner's Manual