DEC MicroVAX 3100 Owner's Manual page 38

the system and set up the system default settings (see Section 2.4). Then
reboot the system using the command:
»>
BOOT DKA300
I
Return
I
After the system has rebooted, status information is displayed as follows:
Startup processing continuing ...
%SET-I-INTEST, login interactive limit=64, current interactive value=O
SYSTEM Job terminated at 31-DEC-1988 15:00:00.00
Accounting information:
Buffered I/O count: 133 Peak working set size: 401
Direct I/O count: 12
Page faults: 325
Charged CPU time: 0 00:00:55.23
Peak virtual size:
Mounted volumes:
Elapsed time:
2379
o
o
00:01:31.24
At this point, the VMS operating system is running. However, you must
perform certain post-installation tasks before you can use the system. Press
RETURN and the system asks you for a user name and password. Log in
to the SYSTEM account as follows:
Welcome to VAX/VMS
USERNAME:
SYSTEM
I
Return
I
PASSWORD:
PANCAKES
I
Return
I
%LICENSE-I-NOLICENSE, no license is active for this software product
%LOGIN-LOGOPRCON, login allowed from OPAO:
Welcome to VAX/VMS
If you do not enter the correct password, the system displays the following
message:
User authorization failure
If you forget your password, follow the instructions for breaking into the
system in the Guide to Setting Up a VMS System.
You should then perform the following operations:
• Register any Product Authorization Keys (PAKs) that you have received
with your system.
• Backup the system disk.
• Delete unwanted VMS files.
To register PAKs, enter the following command:
Installing Your System 2-21