DEC MicroVAX 3100 Owner's Manual page 30

1.
Press the HALT button on the back of the system unit as shown in
Figure 2-2. The system displays the console prompt (»» on a new
line.
2. Set the system default boot device. To use the system with VMS Factory
Installed Software (FIS), enter:
»>
SET BOOT DKA300
I
Return
I
See Appendix A for other possible settings.
3. Set the system default recovery action. To use the system with VMS
FIS, enter:
»>
SET HALT 3
I
Return
I
See Appendix A for other possible settings.
4. Set the system network listener and remote trigger state. To use the
system with VMS FIS, enter:
»>
SET MOP 0
I
Return
I
»>
SET TRIG 0
I
Return
I
This disables the network listener and remote systems request.
5. Check the settings you have just input:
To show the default boot device name, enter:
> > >
SHOW BOOT
I
Return
I
Check that the data returned is the same as that entered in step 2.
To show the default recovery action, enter:
> > >
SHOW HALT
I
Return
I
Check that the value returned is the same as that entered in step 3.
To show the default network listener and remote systems request
settings, enter:
> > >
SHOW MOP
I
Return
I
»>
SHOW TRIG
I
Return
I
Check that the values returned are the same as those entered in
step 4.
If any of the values are incorrect, repeat the operation.
Installing Your System 2-13