Loading Paper - Minolta Di250f Operator's Manual

13-2

1. Loading Paper

This section describes the procedure for putting paper in the paper drawer and changing the paper size.
Useful Tips
• Up to five paper drawers can be installed using additional drawers (optional).
• The following print sizes can be set.
Multi-purpose cassette
Universal cassette
500-sheet cassette
Large Capacity Cabinet
Manual Bypass
• If there is no paper left for printing, the message "Add paper" is displayed on the touch panel. When
the 1st Drawer, Paper feed unit PF-110, or Paper feed unit PF-108 is installed, and the paper runs
out, a red lamp on the paper drawer tray lights. (When the paper is running low, the light flashes
red.)
• Use only the recommended paper.
• Do not use wrinkled, folded, or damp paper or the reverse side of used paper as this may cause a
paper misfeed.
• When the paper size of the drawer is changed, be sure to enter the new paper size through the Touch
panel. (To change the paper size in Paper feed unit PF-108, contact your service center.)
• If the paper size is changed while the power is turned off, reset the paper size on the copy screen after
turning the power on.
Loading paper (1st Drawer)
Pull out the paper drawer.
1
Push down the paper support until it locks.
2
11x17 11x14 Legal Letter Letter 51/2x81/2 51/2x81/2
- - - -
 
 
=Available -=Not Available
-
- -
- -
3 Load a neat sheaf of paper in the drawer,
aligning with the guide.
NOTE
Ensure the paper stack does not exceed the
mark, which indicates the maximum paper
load.
User
OHP Metric
set
- -
- -
- - -