Minolta Di250f Operator's Manual page 66

2-8
2. Selecting the Copy Paper Size for Copying
Load a sheet of paper onto the Manual
7
Bypass Tray.
• Open the Manual Bypass Tray.
• Place a sheet of paper on the tray.
• Adjust the guides to the paper width.
• Insert the paper until the paper hits the stop.
NOTES
• Set the document with the side to be copied
face down.
• Set the document in accordance with the size
and direction of the selected paper.
• Load a single sheet of paper at once.
• Do not use wrinkled, folded, or damp paper
and paper that is already printed on one side
to avoid a paper misfeed.
• Try to insert the paper slightly deeper once
the paper hits the stop.
• If a large sheet of paper is used, support the
loose end by hand so that it does not bend
down.
• When a postcard or thick paper is used,
straighten out the shape before inserting.
• When thick paper, OHP film, postcards, or
labels are used for copying, do not select any
of the 2-Sided copying, Booklet, Stapling, or
Hole punching functions.
Copying starts.
Useful Tip
To copy two or more sheets, consecutive
copying is possible by setting the appropriate
amount of paper on the Manual Bypass Tray.
Special Paper Mode
When
S
paper size selection key, the special paper mode is
set for the paper drawer.
"Settings for Printing"
1166O348AA
There are three types of special paper modes as
follows.
: Recycled paper
S
If this mode has been set, the paper drawer in
which recycled paper has been loaded is not
selected when the automatic paper selection
function is selected. For example, if both normal
and recycled paper are loaded in separate paper
drawers and the normal paper is mainly used, the
normal paper is selected in priority when copying
by setting this mode for recycled paper.
: 2-Sided copying is impossible
2
2-Sided copying is impossible by setting this
mode.
: Special paper
If this mode has been set, the paper is not selected
automatically. Erroneous usage of colored paper
that is intended for use as cover sheets or
separators can be avoided by setting this mode.
Useful Tips
• When the Special Paper Mode is set,
installing the same size paper in two drawers
or more allows the copier to automatically
switch between paper drawers to continue
copying if paper in the first drawer runs out
during copying.
• The paper size selection is reset by touching
the Panel Reset key or will be reset once the
Auto-Reset period has expired. "Settings for
Saving Power"
Copying"
, or is displayed on the
2
p. 9-35
1171P030EA
p. 9-37 "Settings for
p. 9-31