Actions
Step 6
Replace the flatbed unit. See
Did this fix the problem?
Step 7
Replace the controller board. See
page
257.
Did this fix the problem?
CCD service check
Actions
Step 1
Restart the device, and retry the scan/copy job. Repeat this step with a
few copy jobs.
Does the error return?
Step 2
Is the CCD ribbon cable properly connected to J30 on the controller board?
Step 3
Replace the flatbed unit. See
Did this resolve the issue?
Flatbed motor service check
Actions
Step 1
Ensure that the flatbed motor cable JFB1 is connected.
Is the cable connected?
Step 2
Replace the flatbed unit. See
Is voltage present?
Step 3
Replace the controller board. See
page
257.
Did this solve the problem?
"Flatbed assembly removal" on page
"Controller board removal" on
"Flatbed assembly removal" on page
"Flatbed assembly removal" on page
"Controller board removal" on
Diagnostic information
Yes
The problem is solved. Go to step 7.
343.
The problem is solved. Consult the next level
Yes
Go to step 2.
Go to step 3.
The problem is solved. Replace the controller
343.
Yes
Go to step 2.
The problem is solved. Go to step 3.
343.
The problem is solved. Contact the next level
155
7016
No
of support.
No
No issue.
Properly connect cable
to J30.
board. See
"Controller
board removal" on
page
257.
No
Properly connect the
cable.
of support.