Bin Full Service Check - Lexmark MX610 Service Manual

Actions
Step 21
Replace the antenna.
Did this fix the problem?
Step 22
Verify that the antenna is properly connected to the wireless card.
Is it connected correctly?
Step 23
Properly connect the antenna.
Did this fix the problem?
Step 24
Replace the wireless card.
Did this fix the problem?
Step 25
Replace the controller board. See
page 257.
Did this fix the problem?

Bin full service check

Action
Step 1
Update the firmware.
Note: Contact the next level of support for the correct firmware level.
Does the problem remain?
Step 2
Check the bin full sensor cables for continuity.
Is there continuity?
Step 3
Replace the bin full sensor. See
page 325.
Does the problem remain?
"Controller board removal" on
"Bin full sensor/lens removal" on
Diagnostic information
Yes
The problem is solved. Go to step 22.
Go to step 24.
The problem is solved. Go to step 24.
The problem is solved. Go to step 25.
The problem is solved. Contact the next level
Yes
Go to step 2.
Go to step 3.
Go to step 4.
149
7016
No
Go to step 23.
of support.
No
The problem is solved.
Replace the bin full
sensor cable. See "Bin
full sensor cable
removal" on page
327.
If the problem remains,
then go to step 3.
The problem is solved.