Trailing Edge Sensor Removal - Lexmark MX610 Service Manual

8
Remove the two screws (B).
9
Disconnect the cable from the sensor.

Trailing edge sensor removal

1
Remove the left cover. See
2
Remove the right cover. See
3
Remove the rear door and cover. See
318.
4
Remove the power supply. See
5
Remove the power supply shield. See
6
Remove the duplex. See
7
Position the printer so that it sits on its left side.
8
Disconnect the cable JACM1 from the controller board.
9
Release the retainer spring (A) from the bracket (B).
"Left cover removal" on page
"Right cover removal" on page
"Rear exit door removal" on page 317
"Power supply removal" on page
"Power supply shield removal" on page
"Duplex removal" on page
Repair information
239.
252.
and
298.
299.
306
"Rear cover removal" on page
298.
7016