45Y Paper Jams - Lexmark MX610 Service Manual

Actions
Step 6
Remove the ADF rear cover and inspect the ADF cover closed sensor for
dirt and debris.
Is there dirt and debris present?
Step 7
Clean the dirt and debris from the sensor.
Does this fix the issue?
Step 8
Inspect the connections on the ADF relay card in the ADF.
Are all the connections properly connected?
Step 9
Check the ADF cable for continuity.
Is there continuity?
Step 10
Check for signals or voltages from JADF1 on the controller board. Pin 14
and 16 should measure +24VDC. Pins 15 and 22 should measure +3.3VDC.
Are there signals or voltages present?

45y paper jams

[x]-page jam, remove all pages from the output bin. Leave paper in bin. [45y.xx]
Paper jam in the finisher bin
1
Empty the standard bin.
Yes
Go to step 7.
The problem is solved. Go to step 8.
Go to step 9.
Go to step 10.
Replace the ADF. See
"ADF unit removal" on
page
Diagnostic information
81
No
Go to step 8.
Secure all the
connections.
Replace the ADF cable.
See "ADF cable
removal" on page
339.
Replace the controller
board. See
333. board removal" on
page 257.
7016
"Controller