Unsupported Option In Slot [X] [55]; Usb Port [X] Disabled [56]; Weblink Server Not Set Up. Contact System Administrator; User Attendance Messages - Lexmark MX610 Service Manual

Unsupported option in slot [x] [55]

1
Turn off the printer.
2
Unplug the power cord from the electrical outlet.
3
Remove the unsupported option card from the printer controller board, and then replace it with a supported card.
4
Connect the power cord to a properly grounded electrical outlet.
5
Turn the printer back on.

USB port [x] disabled [56]

From the printer control panel, touch Continue to clear the message.
Notes:
• The printer discards any data received through the USB port.
•
Make sure the USB Buffer menu is not set to Disabled.

Weblink server not set up. Contact system administrator.

From the printer control panel, touch Continue to clear the message.
Note: If the message appears again, then contact your system support person.

User attendance messages

User attendance messages (0‑99.99)
Error code Description
31.40 Toner cartridge smart chip error
31.41 Toner cartridge I2C packet timeout
31.42 Toner cartridge I2C packet has been sent but code
timed-out on receiving the data (callback)
31.43 Toner cartridge security error in the send challenge
sequence
31.44 Toner cartridge ROM signature error
31.45 Toner cartridge stuck busy (Status register and/or CRI
Arbiter register report busy)
31.60 Imaging unit smart chip error
Action
Go to "Toner cartridge smart chip contact service
check" on page
Go to "Toner cartridge smart chip contact service
check" on page
Go to "Toner cartridge smart chip contact service
check" on page
Go to "Toner cartridge smart chip contact service
check" on page
Go to "Toner cartridge smart chip contact service
check" on page
Go to "Toner cartridge smart chip contact service
check" on page
Go to "Imaging unit smart chip contact service check"
on page
Diagnostic information
111
112.
112.
112.
112.
112.
112.
113.
7016