Bin Full Sensor Cable Removal - Lexmark MX610 Service Manual

5
Disconnect the cable (J1RED1) from the sensor.
Installation note: When installing this FRU, update the firmware to RIP (LW20.SB7.P231) and Engine (FDN.PIR.E310)
or higher.
Installation warning: This is a mandatory firmware update. Failure to update the firmware will cause the sensor to
prematurely fail, requiring another sensor replacement. This update extends the life of the sensor.

Bin full sensor cable removal

1
Remove the top cover. See
2
Remove the bin full sensor. See
"Top cover removal" on page
"Bin full sensor/lens removal" on page
Repair information
327
324.
325.
7016