Lexmark MX610 Service Manual page 319

3
Remove the rear door and cover. See
318.
4
Remove the scanner assembly. See
5
Remove the top cover. See
6
Disconnect cable JNRW1 from the controller board.
7
Remove the two screws (A), and then disconnect the reverse solenoid.
Note: Do not disconnect the reverse solenoid cable from the controller board.
8
Remove the stapler cable. See
"Rear exit door removal" on page 317
"Scanner assembly removal" on page
"Top cover removal" on page
"Stapler cable removal" on page
Repair information
319
and "Rear cover removal" on page
336.
324.
321.
7016