Lexmark MX610 Service Manual page 168

Error code
884
885
886
887
888
889
88A
901
902
903
904
905
906
Description
Failure to transmit training successfully in V29,
V27 terminal modulation schemes.
Failure to transmit training successfully in V17
terminal modulation scheme.
Failure to transmit training successfully in V29
terminal modulation scheme.
Failure to transmit training successfully in V27
terminal modulation scheme.
Failure to transmit training successfully at 2400
bps in V27 terminal modulation scheme.
Failed to connect at the minimum speed
supported by the MFP.
Failed to connect using V.34 modulation
scheme.
No fax tones detected from remote end.
No dial tone detected.
Busy tone detected.
Hardware error detected.
A timeout occurred after dialing the number
and waiting for a response.
Fax cancelled by user.
Diagnostic information
Action
•
Select a lower "Max Speed" under Fax
Send settings.
•
Adjust the "Transmit Level".
•
Check line quality.
•
Select a lower "Max Speed" under Fax
Send settings.
•
Adjust the "Transmit Level".
•
Check line quality.
•
Select a lower "Max Speed" under Fax
Send settings.
•
Adjust the "Transmit Level".
•
Check line quality.
•
Select a lower "Max Speed" under Fax
Send settings.
• Adjust the "Transmit Level".
• Check line quality.
•
Adjust "Transmit Level".
•
Check line quality.
•
Adjust "Transmit Level".
•
Incompatible connection.
•
Check line quality.
• Adjust to a lower modulation scheme.
• Adjust Transmit Level Receive Threshold
values.
•
Verify destination phone number.
•
Verify that the remote fax is authorized
to receive faxes.
•
Check by enabling 'Behind a PABX'
setting.
•
Check phone line.
•
Check MFD modem hardware.
Check with remote end if successive
attempts fail.
See "Modem/fax card service check" on
page 160.
Check with remote end if successive
attempts fail.
No action needed.
168
7016