Lexmark MX610 Service Manual page 55

Error code Description
200.24 Measured gap at input sensor too small to meet video
delivery requirements. (Not enough time since prior
image finished to start new image).
200.29 Printhead drive control out of range due to an
external event beyond what the control is designed
to handle.
200.30 Invalid printhead NVRAM.
200.31 Paper, in the middle of a job, at input sensor before
interrupt occurred.
200.32 Detected cover switch bounce.
200.33 Input sensor covered too quickly.
200.38 Interpage servo gap smaller than expected for galvo
offset target evaluation.
200.42 Rogue sheet at ACM sensor while flushing the paper
path prior to declaring Tray 1 source empty.
200.44 Page from Tray 1 did not reach the input sensor (or
the manual feed sensor, if present) after multiple pick
attempts. Page did make it out of the tray at least as
far as the ACM sensor.
200.45 During warm up flush, sheet detected too long over
input sensor.
Sensor (input) static jam service check
Action
Step 1
Check the input sensor area for jammed media fragments.
Is the paper path free of partially fed or jammed media?
Step 2
Check the jam access cover if it is blocking the input sensor.
Is it blocking the input sensor?
Step 3
Check the input sensor cable for proper connection.
Is it properly connected?
Action
Go to "Sensor (input) image jam service check" on
page 57.
Go to "Sensor (input) image jam service check" on
page 57.
Go to "Sensor (input) image jam service check" on
page 57.
Go to "Sensor (input) early/late arriving service
check" on page
Go to "Sensor (input) early/late arriving service
check" on page
Go to "Sensor (input) early/late arriving service
check" on page
Go to "Sensor (input) early/late arriving service
check" on page
Go to "Sensor (input) early/late arriving service
check" on page
Go to "Sensor (input) early/late arriving service
check" on page
Go to "Sensor (input) early/late arriving service
check" on page
Yes
Go to step 2.
Replace the jam access
cover. See
cover removal" on
page
Go to step 4.
Diagnostic information
55
56.
56.
56.
56.
56.
56.
56.
No
Clear the paper path of
any media fragments.
Go to step 3.
"Jam access
290.
Reseat the cable.
7016