Printer Setup; Flash Test - Lexmark MX610 Service Manual

1
From the Diagnostics menu, navigate to:
DEVICE TESTS > Disk Test/Clean
Contents will be lost appears.
2
Do one of the following:
• Touch to continue.
•
Press X to cancel.
The test cannot be stopped or canceled after it has begun.
3
After the test is complete, a message appears indicating a pass or fail result.
4
Press X to return to the Device tests menu.

Flash Test

This test verifies the condition of the flash device by writing data to it and then reading data from it.
Warning—Potential Damage: This test destroys all data on the flash device.
Note: After this test is executed, reformat the flash using the Flash Format setting in the Utilities menu.
1
From the Diagnostics menu, navigate to:
Device Tests > Flash Test
Files will be lost. Go/Stop? appears.
2
Do one of the following:
• Depending on the printer model, press OK or touch
•
Press X to cancel.
Note: When the test starts, it cannot be stopped or canceled.
3
After the test is complete, a message appears indicating a pass or fail result.
4
Press X to return to the Device tests menu.
5
Reformat the flash device using the Flash format setting in the Utilities menu.

PRINTER SETUP

Defaults
Warning—Potential Damage: Modification of the printer setting Defaults causes the NVRAM space to be restored to
the printer factory settings.
This setting is used by the printer to determine whether U.S. or non-U.S. factory default values should be used. The
following printer settings have different U.S. and non-U.S. values:
Printer default values
Paper Sizes setting in the General Settings menu
Default Paper Size (paper feeding sources which do not
have hardware size sensing capabilities)
to continue.
U.S. value
U.S.
Letter
Service menus
191
Non-U.S. value
Metric
A4
7016