Pontiac Fiero 1988 Service Manual page 317

6A1-16
2.5L
ENGINE
APPLY RTV SEALANT
AS SPECIFIED
1 - 3 / 8 " WIDEX 3/16" THICK
2-3/16" WIDEX 1/8" THICK
3 - 1 / 8 " BEAD IN AREAS SHOWN
P A N
P
P
r
G20042-6A4
Fig. 805 Oil Pan Sealer Application
Install or Connect
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
RTV, see Fig. 805.
Oil pan, retaining bolts and filter.
Engine front support bracket and mount.
Lower car.
Lower engine onto mounts.
Remove J28467.
Engine strut.
Raise car.
Lower generator bolt (at mount).
A/C compressor bolts.
Heat shield at A/C compressor.
Nuts - front engine mount to cradle.
Splash shield.
Starter.
Starter and flywheel cover.
Right rear wheel.
Lower car.
Generator and serpentine belt.
Trim - at sail panel below battery side panel.
Engine compartment lid and side panels.
Engine oil.
Battery cables.
MOUNT ASM.
J20003-6A4
TIMING GEAR C O V E R / F R O N T S E A L
Remove or Disconnect
Tools Required:
J28467 Engine Support Fixture.
Fig. 806 Engine Support Bracket
J34995 Front Cover Seal Installer.
1. Negative battery cable.
2. Engine compartment lid and side panels.
T
Important
• Scribe hinges for later reassembly.
3. Trim - at sail panel below battery side panel.
4. Serpentine belt.
5. Raise vehicle.
6. Right rear wheel and tire.
7. Inner splash shield.